Serial to Ethernet Contro

Dual mode device: depending on the uploaded firmware it can operate as a fix serial-Ethernet converter or a Basic programmable controller. Every serial device can easily be made ethernet accessible by using a DS1101. It provides a cost-effective, easy to develop alternative compared to embedded Linux systems.

Properties

• 10/100BaseT Ethernet port
• 3.5-channel RS232 port (DB9)
• Power input/output through DB9
• Optional 802.11b/g Wi-Fi interface*
• Optional OLED display
• Optional power-over-Ethernet*
• Compact (90x48x25mm)
• DIN rail, wall mounting plates included
• *Mutually exclusive

Superior upgrade to the DS1206 device. 
Based on the high-performance T1000 IC. 
10/100BaseT, auto-MDIX Ethernet port. 
Optional 802.11b/g Wi-Fi interface. 
Optional 96x32 monochrome OLED display. 
Optional power-over-Ethernet. 
1024KB flash for firmware, application, and data. 
2KB EEPROM for data storage. 
Eight LEDs: 
Green and red main status LEDs; 
Yellow Ethernet link LED; 
Five blue LEDs (can be used for Wi-Fi signal 
strength indication). 
Built-in buzzer. 
3.5-channel RS232 port on DB9M connector: 
TX, RX, RTS, CTS, DTR, DSR, DCD lines; 
Baudrates of up to 921,600 bps; 
None/even/odd/mark/space parity modes; 
7/8 bits/character modes; 
Optional RTS/CTS flow control; 
Flexible mapping with 15 different options, such as: 
1 channel: RX, TX, CTS, RTS, DSR, and DTR; 
3.5 channels: RX, TX, RX2, TX2, RX3, TX3, and 
RX4 lines. 
Programmable “12V” power output on pin 9 of DB9. 
Pin 9 can also be used for “12V” power input. 
Power: 12VDC nominal (min. 9V, max. 18V). 
Software-controlled onboard PLL. 
Dimensions: 90x48x25mm. 
Operating temperature range: -5 ~ 70 C. 
Firmware is upgradeable through the serial port or 
network. 
Included accessories: 
DIN rail mounting plate 
Wall mounting plate and two screws